This tutorial was created by Beate JohnsSupplies
- Two 4 1/4" x 11" pieces of cardstock for your card base
- One 4" x 5" piece of patterned paper
- One 3 3/4" x 5 1/4" piece of cardstock for insert
- One 3 1/2" x 4 3/4" piece of neutral cardstock for insert
- One 1 1/2" x 12" piece of colored cardstock for card band
- More paper for accents
- Corner rounder
Step 1Score both 4 1/4" x 11" pieces of cardstock at 5 1/2".
Step 2Take one scored piece and cut it diagonally from center top to the bottom left.
Step 3Take the other piece of scored cardstock and cut it diagonally from the center top to the bottom right.
Step 4Add adhesive to the rectangle back of one of the cardstock pieces.
Step 5Tape both pieces together. Make sure both long edges of the diagonal sections are on the bottom.
Step 6Cut the patterned paper in half diagonally.
Step 7Adhere it to your card front. I used double sided patterned paper (Dashing, from Stampin' Up!). The dotted paper is on the back of the striped design.
Step 8Add Sticky Strip™on the bottom of the middle panel, as well as on the bottom of the triangle flap that will be on top of the card.
Tape the card base together and set aside.
Step 9Take both pieces of cardstock for the insert and use the corner rounder on the top corners.
Step 10Tape together.
Step 11Stamp and add tab and other embellishments as needed.
Step 12Take the 1 1/2" x 12" piece of colored cardstock and score at 5 5/8" and 11 1/4".
Step 13Add Sticky Strip™ to the end of the strip with the small 3/4" scored section. Tape band together.
Step 14Decorate the card band.
Step 15Slide your band over your card.
Your card is finished!